Sliding or swing gate: which suits your Gold Coast driveway?
Most people start with how a gate looks. The better place to start is your driveway, because the site usually narrows the choice to one type before style comes into it.
Start with the slope
Stand at the street and look up or down the driveway. If it rises or falls in the first few metres inside the boundary, swing gates will struggle. A leaf sweeping across rising ground hits the concrete, so it either has to be cut short at the bottom or hung high with a gap underneath. Neither looks good, and a motor on a dragging leaf works hard every time.
A sliding gate runs across the opening rather than through the slope, so it copes with a rising driveway much better. The track needs a level run, which is set into a footing across the driveway.
Then check the space
A swing gate needs clear space behind it for the leaves to open fully. Measure from the gate line to the nearest obstacle: the garage, a parked car, a garden bed or a step. For a standard double gate, each leaf is roughly half the opening width, so it needs about that much clear space behind it.
A sliding gate needs run-off room beside the opening, roughly as long as the gate itself, where it parks when open. On narrow blocks with a short front fence, there may not be enough. Then the options are a bi-parting sliding gate, which splits the opening in two, or swing gates if the driveway allows.
Setback from the street
Gates must open into your property, never out over the footpath. If the house sits close to the street, swing leaves can hit a car parked in the driveway. A sliding gate avoids that completely.
Automation
Both types can be automated. Sliding gate motors sit on a small plinth beside the gate, driving a gear rack. Swing gates use arms on the posts or underground motors at the hinges. Sliding gates are generally simpler to automate well, because the motor only has to push the gate along a level track. Read more in gate automation.
Looks and cost
Swing gates have a classic, balanced look and suit wide, flat frontages. They are often cheaper because there is no track or footing. Sliding gates look clean and modern, and suit almost any driveway that has the run-off room.
A quick checklist
- Driveway slopes? Lean towards sliding.
- No room for leaves to open? Sliding.
- Short fence line beside the opening? Swing or bi-parting sliding.
- Flat, wide frontage with space behind the gate? Either works, so choose on looks.
Try both in our gate designer, then send us your design with a photo of the driveway.
Ready to plan your new gate?
Tell us about your project to request a free quote.
